Thisĭevice is suited for use in the region mentioned in the Quickstart section. Z-Wave is the international wireless protocol for communication in the Smart Home. Follow the disposal instructions.ĭo not dispose of electronic equipment or batteries in a fire or near open heat sources. Use this equipment only for its intended purpose. ![]() The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Failure to follow the recommendations in this manual may be dangerous or may violate the law. Manufacturers Manual for more information. 6.If a red LED turns ON, try repeating steps 1-3Interactive Instruction for AddĪttention: This manual is automatically generated fromĭata and may be incomplete. The PIN Code portion of the Z-Wave DSK will be needed.5.When a green LED turns ON, the Add or Inclusion has completed successfully. If the Security Scheme is Security 2 (S2), verify the DSK of the lock at the Z-Wave Controller. 3.Press then release the button on the PCB.4.An LED will flash amber indicating the Add or Inclusion process is in progress. ![]() 2.Remove the battery cover of the deadbolt. One-button Add lock to Z-Wave Network (Inclusion) 1.Place your home automation system or panel into the Add or Inclusion Mode (Refer to the respective documentation for that specific home automation system or panel device for details). To add this device to your network execute the following action: ![]() Please make sure the internal battery is fully charged. This is a secure Door Lock - Keypad for U.S.
0 Comments
Leave a Reply. |